Nespresso Troubleshooting Pixie

Pixie

Please follow the instructions below or watch the video.
Remove the plastic film from the drip grid.
Remove the water tank and capsule container. Adjust the cable length and store the excess under the machine.
Insert the remaining cable in the cable guide under the machine and put the machine in the upright position.
Plug the machine directly into the 220 volt mains.
Rinse the water tank before filling with potable water.
Switch the machine on. Blinking light of both coffee buttons and the capsule container: heating up for approximately 25 seconds. Steady light: ready.
Place a container under coffee outlet and press the Lungo button to rinse the machine. Repeat three times.

Please follow the instructions below or watch the video.
Rinse then fill the water tank with potable water. The water tank can be carried by its cover.
Switch the machine on. Blinking light: heating up for approximately 25 seconds. Steady light: ready.
Lift the lever completely and insert the capsule.
Close the lever and place a cup under the coffee outlet.
During heat up, you can press the coffee button when it’s still blinking. The coffee will then flow automatically when the machine is ready.
For a Latte Macchiato glass fold the cup support into the upright position. It will automatically fall down again when removing the glass to avoid any drips falling on to your kitchen surfaces.
Press the Espresso (40 ml) or the Lungo (110 ml) button. Preparation will stop automatically. To stop the coffee flow or top up your coffee, press again.
Take the cup. Lift and close the lever to eject the capsule into the used capsule container.

Switch the machine off.
Remove the water tank. Close the Lever. Place a container under the coffee outlet.
Press and hold the Espresso button and switch the machine on. Wait until no more water comes out.
Machine switches off automatically.

Do not use any strong cleaning agent or solvent cleaner. Do not put in a dishwasher.
Never immerse the appliance or part of it in water.
Clean the coffee outlet regularly with a damp cloth.
To assemble the cup support and the drip tray: take off the grid, place them side by side and clip the drip tray to the cup support.

Please follow the instructions below or watch the video.
Remove the capsule and close the lever.
Empty the drip tray and the used capsule container.
Fill the water tank with 0.5 litre of water and add the Nespresso descaling liquid.
Place a container (minimum volume: 0.6 litre) under the coffee outlet.
Switch the machine on.
Blinking light: heating up. Steady light: ready.
Press both coffee buttons simultaneously for three seconds. They will start blinking.
Press the Lungo button and wait until the water tank is empty.
Refill the water tank with the used descaling solution collected in the container and repeat step 8.
Empty and rinse the water tank. Fill it with potable water.
When ready, press the Lungo button to rinse machine.
To exit the descaling mode, press both buttons simultaneously for three seconds. The machine is now ready for use.
Caution: The descaling solution can be harmful. Avoid contact with eyes, skin and surfaces. We recommend the Nespresso descaling kit as it is specifically adapted to your machine. Do not use other products (such as vinegar) that would affect the taste of the coffee.

To save energy, switch the machine off when not in use.
Automatic power off: the machine will stop automatically after 9 minutes of non use.
To increase automatic power off from 9 to 30 minutes: switch the machine off, press the Espresso and Lungo buttons simultaneously then press the ON/OFF button.
Red backlight lights up: water tank is empty. Refill the water tank with potable water. Empty and rinse the used capsule container and the drip tray.

Check the water tank, if empty, fill with potable water. Descale it if necessary..
Lift the lever. Press one coffee button and wait until water comes out.